Directional air distribution SectorJet™ Conventional air distribution can leave parts of a room under-conditioned, with warm spots, stagnant zones and uneven humidity that affect crop uniformity and mould pressure. SectorJet™ directs the airflow across the full cultivation or drying space, so conditions are more even from wall to wall. Fewer dead zones More uniform room climate Consistent crop quality
Grow-phase logic ClimaFlow 3X™ Fixed climate settings do not match the changing needs of propagation, vegetative growth, flowering or drying. ClimaFlow 3X™ adapts the system behaviour to each phase, keeping the climate strategy aligned with the crop or product stage from start to finish. Adapts to each phase Fewer manual adjustments Consistent results
Intelligent dehumidification HyperDR-AI™ Dehumidifying in hard on-off cycles causes humidity swings, temperature changes and energy peaks, especially when transpiration or drying loads change. HyperDR-AI™ matches moisture removal to real-time demand, keeping relative humidity stable. Stable RH control Fewer energy peaks Follows the actual load
Airflow precision AERO-S™ Even with enough capacity, an unsuited airflow strategy can leave zones with uneven air movement and weak canopy penetration. AERO-S™ optimises air throw and circulation across the room, improving climate uniformity where the crop needs it. Canopy penetration Optimised air throw Stable circulation
Adaptive compressor control A-SPEC™ Seasonal changes and shifting heat and humidity loads can move a system away from its optimal operating point. A-SPEC™ adapts the system behaviour to the actual operating conditions, throughout the year. Adapts to the season Stable under changing loads Efficient operation
Energy recovery RE-ACT™ Cooling and dehumidification release heat that often goes unused. RE-ACT™ recovers and reuses available heat within the climate process, lowering energy use and operating costs. Reuses available heat Lower operating costs Higher overall efficiency
Variable capacity Infinity DC Inverter Fixed-capacity compressors run at full power until the setpoint is reached and then switch off, causing temperature swings, RH drift and wear. The DC inverter modulates compressor output to match the demand of the room. Fewer on-off cycles Stable room conditions Efficient at part load
Spectrum control PhytoVegSpec® Spectral quality and intensity can be set for each growth phase, with a blue to red ratio from 1:1 to 1:6, programmable schedules, gradual sunrise and sunset, and far-red after the day ends. Spectrum and intensity per growth phase Blue to red from 1:1 to 1:6 Programmable schedules
Crop protection Integrated ioniser An ioniser with cold plasma technology is built into the fixture and releases ions close to the crop, where they reduce airborne pathogens. It can be set per room or switched off, and ozone stays below the detection limit. Fewer airborne pathogens Released close to the crop No detectable ozone
Optics Deep Penetration Lens A high-transmittance lens with a wide 90° by 120° beam directs light deep into the canopy, so lower leaves also contribute to photosynthesis and light is spread evenly over the growing surface. Deeper canopy penetration Even light distribution Wide 90° × 120° beam
Work light Multi Color Light Pipe Auxiliary RGB lighting in the fixture serves as a red, blue or green work or night light. A radar sensor switches it on when someone enters the room, without disturbing the day cycle. Work light in red, blue or green Switches on when someone enters Does not disturb the day cycle
Optics for vertical farming VertiLED lens design A segmented PMMA lens with asymmetric secondary optics, mounted at an angle, spreads light evenly across the full width of the grow bed. The lens does not block UV-A and does not yellow over time. Even light edge to edge Does not block UV-A Does not yellow
Spectrum add-ons UV add-on optics NIR and UV-A or UV-B add-ons extend the spectrum for specific crops and research. Dedicated optics and a compact reflector direct the added light where it is needed, and a radar sensor switches UV-B off when someone enters. Extend the spectrum with NIR, UV-A or UV-B Dedicated optics per add-on UV-B switches off when someone enters