Spectrum control PhytoVegSpec® Spectral quality and intensity can be set for each growth phase, with a blue to red ratio from 1:1 to 1:6, programmable schedules, gradual sunrise and sunset, and far-red after the day ends. Spectrum and intensity per growth phase Blue to red from 1:1 to 1:6 Programmable schedules
Crop protection Integrated ioniser An ioniser with cold plasma technology is built into the fixture and releases ions close to the crop, where they reduce airborne pathogens. It can be set per room or switched off, and ozone stays below the detection limit. Fewer airborne pathogens Released close to the crop No detectable ozone
Optics Deep Penetration Lens A high-transmittance lens with a wide 90° by 120° beam directs light deep into the canopy, so lower leaves also contribute to photosynthesis and light is spread evenly over the growing surface. Deeper canopy penetration Even light distribution Wide 90° × 120° beam
Work light Multi Color Light Pipe Auxiliary RGB lighting in the fixture serves as a red, blue or green work or night light. A radar sensor switches it on when someone enters the room, without disturbing the day cycle. Work light in red, blue or green Switches on when someone enters Does not disturb the day cycle
Optics for vertical farming VertiLED lens design A segmented PMMA lens with asymmetric secondary optics, mounted at an angle, spreads light evenly across the full width of the grow bed. The lens does not block UV-A and does not yellow over time. Even light edge to edge Does not block UV-A Does not yellow
Spectrum add-ons UV add-on optics NIR and UV-A or UV-B add-ons extend the spectrum for specific crops and research. Dedicated optics and a compact reflector direct the added light where it is needed, and a radar sensor switches UV-B off when someone enters. Extend the spectrum with NIR, UV-A or UV-B Dedicated optics per add-on UV-B switches off when someone enters